after some careful thought and consideration I've realised i can use the modular pieces to create 3 of the walls and 3 walls will need to be modelled separately due to spacing.
The walls that need to be done separately are the front door wall and the small wall by the side, this has been connected to a modified corner piece for the inside of the cabin, and the left hand side wall.
Today has been very much trial and error, I've gotten to the point now where i need to call it a night or am going to end up completely redoing the wall structure, maybe thats what i need to do in a sense, make the cylinders again cap them at certian points and make them unique that way? tonight i began to notice how the wall pieces didn't line up perfectly as i started to model the second floor wall pieces. fortunately the day doesn't seem completely wasted as did the roofing structure and i started on some of the bedroom assets such as a chest of draws and a desk/table
I wont be working much on this next week as i have to go home for a family matter meaning i wont have access to my pc with max on. i might be able to get some concept work done for this however other modules require my attention, i should start working back up on FYP on friday 8th.
Note to self: Create cylinders> vary sizes> cap ends (middle wont be effected)> ctrlX drag verts to place (trace corner pieces) see if that works.
No comments:
Post a Comment